Pepperl-Fuchs

This page contains the following files:

IOLM DR-8-PNIO Firmware

Description Supports IOLM DR-8-PNIO

U-Boot Bootloader 1.30
FPGA v1.03
System Primary/Backup uImage v1.36
Application Base v1.5.28

Please contact Pepperl + Fuchs Technical Support for firmware by selecting the Contact Us tab.

PortVision DX

Operating System Version Description

Windows XP SP3 through Windows 10
(32/64-bit)

v5.01

You can use PortVision DX to identify, configure, update, and manage the IO-Link Master and all other Pepperl+Fuchs Comtrol, Inc. Ethernet-attached devices.

  

You can use PortVision DX to perform the following tasks:

  

  • Configure the IP address
  • Upload the latest images or application sub-assemblies
  • Access the IO-Link Master web configuration interface
  • Save/load configuration files
  • Reboot the IO-Link Master
  • Reset to factory

    • default values

  • Access a Telnet/SSH session
  • Toggle the IO-Link Master LEDs in the event you need to locate a specific IO-Link Master

  

Procedures to configure the IP address and upload software is available in the navigational bar at the left for your model.

  

You can use the help system for information about using PortVision DX.

IOLM DR-8-PNIO GSDML Files

Model Supported Application Base Version File Description

IOLM 4-PNIO
IOLM 8-PNIO
IOLM 8-PNIO-L
IOLM DR-8-PNIO
IOLM DR-8-PNIO-P
IOLM DR-8-PNIO-T

1.5.28

v2.34-20181102

If you need information about installing the GSDML file, refer to the IO-Link Master User Guide for PROFINET IO.

IOLM DR-8-PNIO Open Source Files

Open Source File Version

kernel

v1.02

buildroot

v1.04

application - JSON-C

v1.2.0.0

uboot

v1.06

IOLM DR-8-PNIO Documentation

Documentation Version Description

IO-Link Master PROFINET IO and Modbus/TCP User Guide

Rev E

This document contains installation and configuration procedures for all IOLM DR-PNIO models. In addition, it contains all of the reference information needed for the PROFINET IO and Modbus/TCP interfaces.